D-Link DXS-3326GSR - Page 137

DXS-3326GSR Gigabit Layer 3 Switch
Figure 7- 3. IP Interface Configuration – Add window
Figure 7- 4. IP Interface Configuration – Edit window
Choose a name for the interface to be added and enter it in the Interface Name field (if you are editing an IP Interface, the
Interface Name will already be in the top field as seen in the window above). Enter the interface’s IP address and subnet
mask in the corresponding fields. Pull the State pull-down menu to Enabled and click Apply to enter to make the IP
interface effective. To view entries in the IP Interface Table, click the Show All IP Interface Entries
hyperlink. Use the
Save Settings window from the Maintenance folder to enter the changes into NV-RAM.
The following fields can be set:
Parameter Description
Interface Name
This field displays the name for the IP interface. The default IP interface is named
“System”.
IP Address
This field allows the entry of an IP address to be assigned to this IP interface.
Subnet Mask
This field allows the entry of a subnet mask to be applied to this IP interface.
VLAN Name
This field allows the entry of the VLAN Name for the VLAN the IP interface belongs to.
Secondary
Use the pull-down menu to set the IP interface as True or False. True will set the
interface as secondar
y
and False will denote the interface as the
p
rimar
y
interface of
124