D-Link DXS-3326GSR - Page 166

DXS-3326GSR Gigabit Layer 3 Switch
Figure 7- 33. OSPF Interface Settings – Edit window
Configure each IP interface individually using the OSPF Interface Settings - Edit menu. Click the Apply button when
you have entered the settings. The new configuration appears listed in the OSPF Interface Settings window. To return to
that window, click the Show All OSPF Interface Entries
link.
OSPF interface settings are described below. Some OSPF interface settings require previously configured OSPF settings.
Read the descriptions below for details.
Parameter Description
Interface Name
Displays the of an IP interface previously configured on the Switch.
Area ID
Allows the entry of an OSPF Area ID configured above.
Router Priority (0-
255)
Allows the entry of a number between 0 and 255 representing the OSPF priority of the
selected area. If a Router Priority of 0 is selected, the Switch cannot be elected as the
Designated Router for the network.
Hello Interval (1-
65535)
Allows the specification of the interval between the transmission of OSPF Hello
packets, in seconds. Between 1 and 65535 seconds can be specified. The Hello
Interval, Dead Interval, Authorization Type, and Authorization Key should be the same
for all routers on the same network.
Dead Interval (1-
65535)
Allows the specification of the length of time between the receipt of Hello packets from
a neighbor router before the selected area declares that router down. An interval
between 1 and 65535 seconds can be s
p
ecified. The Dead Interval must be evenl
y
153