DXS-3326GSR Gigabit Layer 3 Switch
Figure 10- 8. Tx Packets Analysis window (table for Bytes and Packets)
The following fields may be set or viewed:
Parameter Description
Unit
Select the unit to display statistics for.
Port
Select the port to display statistics for.
Clear
Clicking this button clears all statistics counters on this window.
Time Interval
Select the desired setting between 1s and 60s, where "s" stands for seconds. The
default value is one second.
Record Number
Select number of times the Switch will be polled between 20 and 200. The default
value is 200.
Bytes
Counts the number of bytes successfully sent from the port.
Packets
Counts the number of packets successfully sent on the port.
Unicast
Counts the total number of good packets that were transmitted by a unicast address.
Multicast
Counts the total number of good packets that were transmitted by a multicast
address.
Broadcast
Counts the total number of good packets that were transmitted by a broadcast
address.
Show/Hide
Check whether or not to display Bytes and Packets.
209
To Next Page
Loading...
