xStack® DES-3200 Series Layer 2 Managed Fast Ethernet Switch
21
To view this window, click System Configuration > Command Logging Settings, as shown below:
Figure 2-19 Command Logging Settings window
The fields that can be configured are described below:
Parameter Description
Use the radio buttons to enable or disable the function.
Click the Apply button to accept the changes made.
NOTE: When the switch is under the booting procedure, all configuration commands will not be
logged. When the user uses AAA authentication to logged in, the user name should not be
changed if the user has used the Enable Admin function to replace its privilege.
To Next Page
Loading...
