xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Manual
15
1
Example usage:
To display the PVID auto-assignment state:
DES-3200-28:4#show pvid auto_assign
Command: show pvid auto_assign
PVID Auto-assignment: Enabled
DES-3200-28:4#
config gvrp
Used to co
nfigure GVRP on the Switch.
Purpose
config gvrp [<portlist
> | all] {state [enable | disable] |
ingress_checking [enable | disable] | acceptable_frame [tagged_only
| admit_all] | pvid <vlanid 1-4094>} (1)
Syntax
This
command is used to configure the Group VLAN Registration
Protocol on the Switch. Ingress checking, the sending and receiving
of GVRP information, and the Port VLAN ID (PVID) can be
configured.
Description
Parameters
<portlist> A port or range of ports for which users want to enable
GVRP for.
all Specifies all of the ports on the Switch.
state [enable | disable] Enables or disables GVRP for the ports
specified in the port list.
ingress_checking [enable | disable] Enables or disables ingress
checking for the specified port list.
acceptable_frame [tagged_only | admit_all] – This parameter states
the frame type that will be accepted by the Switch for this function.
tagged_only implies that only VLAN tagged frames will be accepted,
while admit_all implies tagged and untagged frames will be accepted
by the Switch.
pvid <vlanid 1-4094> – Specifies the default VLAN associated with
the port.
Only Administrator-level users
can issue this command.
Restrictions
Example usage:
To set ingress checking status and the sending and receiving of GVRP information:
DES-3200-28:4#config gvrp 1-
To Next Page
Loading...
Need help?
General
