D-Link xStack DES-3200 Series - enable ssl

xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Manual
28
2
config ssh user
identify the SSH user.
authmode – Specifies the authentication mode of the SSH user wishing
to log on to the Switch. The administrator may choose between:
hostbased – This parameter should be chosen if the user wishes to
use a remote SSH server for authentication purposes. Choosing
this parameter requires the user to input the following information
to identify the SSH user.
hostname <domain_name 32>  Enter an alphanumeric string of up to 32
characters identifying the remote SSH user.
hostname_IP <domain_name 32> <ipaddr>  Enter the hostname and the
corresponding IP address of the SSH user.
password – This parameter should be chosen to use an
administrator defined password for authentication. Upon entry of
this command, the Switch will prompt the user for a password,
and then to retype the password for confirmation.
publickey – This parameter should be chosen to use the publickey on
a SSH server for authentication.
Only Administrator-level users
can issue this command.
Restrictions
Example usage:
To configure the SSH user:
DES-3200-28:4# config ssh user Zira authmode password
Command: config ssh user Zira authmode password
Success.
DES-3200-28:4#
show ssh user authmode
Used to displ
ay the SSH user setting.
Purpose
sho
w ssh user authmode
Syntax
This
command is used to display the current SSH user setting.
Description
Non
e.
Parameters
Only Administrator-level users
can issue this command.
Restrictions
Example usage:
To display the SSH user: