xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Manual
28
3
DES-3200-28:4#show ssh user authmode
Command: show ssh user authmode
Current Accounts:
Username AuthMode HostName HostIP
---------- --------- ------------------------- ---------------
Zira Password
Total Entries : 1
DES-3200-28:4#
Note:
To configure the SSH user, the administrator must create a user account
on the Switch. For information concerning configuring a user account, please
see the section of this manual entitled Basic Switch Commands and then the
command, create account.
config ssh algorithm
Used to co
nfigure the SSH algorithm.
Purpose
config
ssh algorithm [3DES | AES128 | AES192 | AES256 | arcfour |
blowfish | cast128 | twofish128 | twofish192 | twofish256 | MD5 | SHA1
| RSA | DSA] [enable | disable]
Syntax
This
command is used to configure the desired type of SSH algorithm
used for authentication encryption.
Description
3DES – This
parameter will enable or disable the Triple_Data
Encryption Standard encryption algorithm.
Parameters
AES128 This parameter will enable or disable the Advanced
Encryption Standard AES128 encryption algorithm.
AES192 This parameter will enable or disable the Advanced
Encryption Standard AES192 encryption algorithm.
AES256 This parameter will enable or disable the Advanced
Encryption Standard AES256 encryption algorithm.
arcfour This parameter will enable or disable the Arcfour encryption
algorithm.
blowfish This parameter will enable or disable the Blowfish
encryption algorithm.
cast128 This parameter will enable or disable the Cast128
encryption algorithm.
twofish128 This parameter will enable or disable the twofish128
encryption algorithm.
twofish192 This parameter will enable or disable the twofish192
encryption algorithm.
MD5 This parameter will enable or disable the MD5 Message Digest
encryption algorithm.
SHA1 This parameter will enable or disable the Secure Hash
Algorithm encryption.
RSA This parameter will enable or disable the RSA encryption
algorithm.