xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Manual
39
2
Example usage
To enable address binding DHCP snooping:
DES-3200-28:4#enable address_binding dhcp_snoop
Command: enable address_binding dhcp_snoop
Success.
DES-3200-28:4#
disable address_binding dhcp_snoop
Used to disab
le the address binding auto mode.
Purpose
disa
ble address_binding dhcp_snoop
Syntax
This
command is used to disable the function which allows entries to be
created by the DHCP packet. When the DHCP snooping function is
disabled, all of the auto-learned binding entries will be removed.
Description
Non
e.
Parameters
Only Administrator-level users
can issue this command.
Restrictions
Example usage
To disable address binding DHCP snooping:
DES-3200-28:4#disable address_binding dhcp_snoop
Command: disable address_binding dhcp_snoop
Success.
DES-3200-28:4#
clear address_binding dhcp_snoop binding_entry
Used to cle
ar the address binding entries learned for the specified ports.
Purpose
clea
r address_binding dhcp_snoop binding_entry ports [<portlist> | all]
Syntax
This
command is used to clear the address binding entries learned for
the specified ports.
Description
ports
- Specifies the list of ports that you would like to clear the dhcp-
snoop learned entry.
Parameters
Only Administrator-level users
can issue this command.
Restrictions
Example usage
To clear address binding DHCP snooping binding entries for ports 1 to 3:
DES-3200-28:4#clear address_binding dhcp_snoop binding_entry ports 1-3
Command: clear address_binding dhcp_snoop binding_entry ports 1-3
Success.
DES-3200-28:4#
To Next Page
Loading...
Need help?
General
