xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Manual
39
3
config address_binding dhcp_snoop max_entry
Used to sp
ecify the maximum number of entries which can be learned by
the specified ports.
Purpose
config a
ddress_binding dhcp_snoop max_entry ports [<portlist> | all] limit
[<value 1-10> | no_limit]
Syntax
This
command is used to specify the maximum number of entries which
can be learned by the specified ports. By default, the per port maximum
entry is 5.
Description
<po
rtlist> - Specifies the list of ports that you would like to set the
maximum dhcp-snoop learned entry.
Parameters
limit - Specifies the maximum number.
Only Administrator-level users
can issue this command.
Restrictions
Example usage
To set the maximum number of entries that ports 1 to 3 can learn up to 10:
DES-3200-28:4#config address_binding dhcp_snoop max_entry ports 1-3 limit 10
Command: config address_binding dhcp_snoop max_entry ports 1-3 limit 10
Success.
DES-3200-28:4#
config address_binding recover_learning ports
Used to unfre
eze the learning of new addresses on a set of ports.
Purpose
config a
ddress_binding recover_learning ports [<portlist> | all]
Syntax
This
command is used to allow the Switch to learn new addresses again
on ports which previously reached the stop learning threshold for blocked
addresses.
Description
Non
e.
Parameters
Only Administrator-level users
can issue this command.
Restrictions
Example usage
To disable address binding DHCP snooping:
DES-3200-28:4#config address_binding recover_learning ports 6-7
Command: config address_binding recover_learning ports 6-7
Success.
DES-3200-28:4#
To Next Page
Loading...
Need help?
General
