D-Link xStack DES-3200 Series

xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Manual
39
8
enable loopdetect
Used to glob
ally enable the loop-detect function on the Switch.
Purpose
enabl
e loopdetect
Syntax
This
command is used to allow the loop detection function to be globally enabled on the Switch.
The default value is disabled.
Description
Non
e.
Parameters
Only Administrator-level users
can issue this command.
Restrictions
Example usage :
To enable loopback detection on the Switch:
DES-3200-28F:4# enable loopdetect
Command: enable loopdetect
Success.
DES-3200-28F:4#
disable loopdetect
Used to glob
ally disable the loopback detection on the Switch.
Purpose
disa
ble loopdetect
Syntax
This
command is used to globally disable the loopback detection on the Switch. The
default value is disabled.
Description
Non
e.
Parameters
Only Administrator-level users
can issue this command.
Restrictions
Example usage
To disable the loopback detection function on the Switch:
DES-3200-28F:4# disable loopdetect
Command: disable loopdetect
DES-3200-28F:4#