D-Link xStack DES-3200 Series - Page 434

xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Manual
42
9
show authorization
Used to displ
ay authorization for attributes status.
Purpose
sho
w authorization
Syntax
Used this
to view authorization for attributes status.
Description
Non
e.
Parameters
Non
e.
Restrictions
Example usage:
This example displays authorization status:
DES-3200-28F:4# show authorization
Command: show authorization
Authorization for Attributes: Enabled
DES-3200-28F:4#
config mac_based_access_control trap state
Used to ena
ble or disable sending of MAC-based Access Control traps.
Purpose
config ma
c_based_access_control trap state [enable | disable]
Syntax
Whe
n MAC-based Access Control trap state is enabled, The trap of MAC-based
Access Control will be sent out.
Description
If the MAC-based Access Control trap state is disabled, no trap will be sent out.
enabl
e – To enable sending MAC-based Access Control traps.
Parameters
disable – To disable sending MAC-based Access Control traps.
Only Administrator-level users
can issue this command.
Restrictions
Example usage:
To enable trap state of MAC-based Access Control:
DES-3200-28F:4# config mac_based_access_control trap state enable
Command: config mac_based_access_control trap state enable
Success.
DES-3200-28F:4#