D-Link xStack DES-3200 Series - Page 459

xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Manual
45
4
config cfm ports
This
command is used to enable or disable the CFM function on a per-port basis.
Purpose
config
cfm ports <portlist> state [ enable | disable]
Syntax
By default, th
e CFM function is disabled on all ports.
Description
If the CFM is disabled on a port the following conditions apply:
MIPs are never created on that port.
MEPs can still be created on that port, and the configuration can be saved.
MEPs created on that port can never generate or process CFM PDUs. If the user issues a
Loopback or Link trace test on those MEPs, it will prompt the user to inform them that the
CFM function is disabled on that port.
ports
<portlist> - The list of logical ports to be configured.
Parameters
state - [enable | disable] - Enables or disables the CFM function on the listed ports.
Only Administrator-level users
can issue this command.
Restrictions
Example usage:
To configure CFM state for ports 2-5:
DES-3200-28F:4# config cfm ports 2-5 state enable
Command: config cfm ports 2-5 state enable
Success.
DES-3200-28F:4#
show cfm ports
This
command is used to show the CFM state of specified ports.
Purpose
sho
w cfm ports <portlist>
Syntax
This
command is used to show the CFM state for specified ports.
Description
ports
<portlist> - The list of logical ports for which to display CFM configuration.
Parameters
Non
e.
Restrictions