D-Link xStack DES-3200 Series - Page 57

xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Manual
52
Exam
ple usage:
To display the currently entered SNMP community strings:
DES-3200-28:4#show snmp community
Command: show snmp community
SNMP Community Table
Community Name View Name Access Right
------------------ ------------------- ------------
private CommunityView read_write
public CommunityView read_only
dlink ReadView read_write
Total Entries: 3
DES-3200-28:4#
config snmp engineID
Used to co
nfigure an identifier for the SNMP engine on the Switch.
Purpose
config snmp engin
eID <snmp_engineID 10-64>
Syntax
This
command is used to configure an identifier for the SNMP
engine on the Switch.
Description
Parameters
<snmp_engineID 10-64>  An alphanumeric string that will be used
to identify the SNMP engine on the Switch.
Only Administrator-level users
can issue this command.
Restrictions
Example usage:
To give the SNMP agent on the Switch the name “0035636666”:
DES-3200-28:4#config snmp engineID 0035636666
Command: config snmp engineID 0035636666
Success.
DES-3200-28:4#