D-Link xStack DES-3200 Series - Page 75

xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Manual
70
config firmware
Used to co
nfigure the firmware section image as a boot up section,
or to delete the firmware section
Purpose
config firm
ware image_id <value 1-2> [delete | boot_up]
Syntax
This
command is used to configure the firmware section image. The
user may choose to remove the firmware section or use it as a boot
up section.
Description
image_i
d – Specifies the working section image. The Switch can
hold two firmware versions for the user to select from, which are
specified by image ID.
Parameters
delete – Entering this parameter will delete the specified firmware
section image.
boot_up – Entering this parameter will specify the firmware image ID
as a boot up section image.
Only Administrator-level users
can issue this command.
Restrictions
Example usage:
To configure firmware section image 1 as a boot up section:
DES-3200-28:4# config firmware image_id 1 boot_up
Command: config firmware image_id 1 boot_up
Success.
DES-3200-28:4#