D-Link xStack DES-3200 Series - Page 93

xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Manual
88
show log
Used to displ
ay the switch history log.
Purpose
sho
w log {index <value_list X-Y>}
Syntax
This
command is used to display the contents of the Switch’s
history log.
Description
Parameters
index <value_list X-Y>  This command will display the history log,
beginning and ending at the value specified by the user in the
<value_list X-Y> field.
If no parameter is specified, all history log entries will be displayed.
Non
e.
Restrictions
Example usage:
To display the switch history log:
DES-3200-28:4#show log index 1-5
Command: show log index 1-5
Index Data Time Log Text
----- -------------------- ------------------------------------------------------
5 00000-00-00 01:01:09 Successful login through Console (Username: Anonymous)
4 00000-00-00 00:00:14 System warm start
3 00000-00-00 00:00:06 Port 25 link up, 1000Mbps FULL duplex
2 00000-00-00 00:00:01 Port 25 link down
1 00000-00-00 00:06:31 Port 25 link up, 1000Mbps FULL duplex
DES-3200-28:4#
enable syslog
Used to ena
ble the system log to be sent to a remote host.
Purpose
enabl
e syslog
Syntax
This
command is used to enable the system log to be sent to a
remote host.
Description
Non
e.
Parameters
Only Administrator-level users
can issue this command.
Restrictions
Example usage:
To enable the syslog function on the Switch:
DES-3200-28:4#enable syslog
Command: enable syslog
Success.
DES-3200-28:4#