Pilot's Operating Handbook
Section 8
Handling, servicing and maintenance
Edition 1 - January 15, 2018
Rev. 5
Page 8.9.1
8.9 - Preparation of the airplane (equipment and furnishings)
▲ WARNING ▲
For
all cabin layouts, make sure that access to emergency exit is
free at all times.
▲
▲ CAUTION ▲
Removed equipment items must be stored in a manner that ensures
their integrity.
▲
Numerous cabin layout configurations are authorized by airplane manufacturer. They
are outlined in section 7.
This procedure specifies how to change the 6-seat layout into a 4-seat configuration,
and vice versa. Also, it can be used partly to remove or install equipment items.
However, it is the pilot's responsibility to ensure that all necessary authorizations are
obtained from the appropriate regulatory authority.
1 -- Conversion of 6-seat accommodation into 4-seat accommodation -
see figures 8.9.1, 8.9.2, 8.9.3 and 8.9.4
A - Tools and consumable materials
- Seat protective covers
B - Preparation
1) Make sure the SOURCE selector is set to OFF and the crash lever is
down.
C - Removal of rear seats - see figure 8.9.1
1) To remove rear seats, perform the following operations
▲ CAUTION ▲
To prevent damage to seat cushion covers, protective covers should be
put on the seats.
▲
a) Install protective covers.
To Next Page
Loading...
