Pilot's Operating Handbook
Section 8
Handling, servicing and maintenance
Edition 1 - January 15, 2018
Rev. 4
Page 8.9.5
c) Position the seat and put lock (22) near the color mark (37) made
on rail bottom on aisle side.
● NOTE ●
The color mark (37) in the rail is aligned with red marks (36).
●
>> Airplane with seats heaters system (Post-MOD70-0588-25)
d) Open the floor hatch and remove clip from holder located under
floor panel and connect heating system harness (26). Clip
connectors on the holder located on the seat structure.
>> All
e) Pull up locking handle (21), insert pads (23) into rail (24)
apertures and then, move the seat so that lock (22) is in front of
the color mark (37).
f) Release locking handle (21) to lock the seat.
▲ WARNING ▲
Verify that lock (22) and all pads (23) are engaged and locked into
rails, trying to move seat forward and backward.
▲
g) Install backrest bottom upholstery (25).
● NOTE ●
Adjust it properly; make sure not to obstruct deflector (34) outlet.
●
h) Slide properly the carpet under the seat.
i) Remove protective covers.
H - Final operations
1) If removed, install cabin central carpet suited to the intended use.
● NOTE ●
Slide properly the carpet under doorstep.
●
2) If necessary, remove the baggage compartment partition net and
install the small or large cargo net - refer to section 7.
3) Make sure the work area is clean and free from debris.
4) Determine weight and balance - refer to section 6.
To Next Page
Loading...
