Test Operation SiE33-102
66 General Information
Mode Changing Procedure
Note: 1. If you become unsure of how to proceed, push the MODE button (BS1) and return to setting mode 1.
2. Power reset is not necessary after setting of setting mode 1 (including C/H select SS1) and setting
mode 2.
3 Monitor mode
Select check items with
the operation button.
Contents displayed
Press the
RETURN button.
Press the
RETURN button.
2 Setting mode 2
Select items with the
operation button.
Select setting items
with the operation button.
Press the
RETURN button.
Press the
RETURN button.
Press the
RETURN button.
Contents displayed
Select cool/heat run
with the operation button
.
Select low-noise run with
the operation button.
Press the
RETURN button.
Press the
SET button.
Press the
RETURN button.
Press the
RETURN button.
Select sequential start
with the operation button.
Press the
MODE button.
Press the MODE button.
Press the MODE
button.
1 Setting mode 1
(initial status)
Hold down the MODE
button for 5 seconds.
: Use the SET button to make settings.
Set Set
Set
Set
Set
Set
Set
Note. 1
(V1329)
Si33-102.book Page 66 Tuesday, June 26, 2001 3:18 PM
Все каталоги и инструкции здесь: http://splitoff.ru/tehn-doc.html
To Next Page
Loading...
Need help?
General
