Test Operation SiE33-102
88 General Information
Note: 1. All the setting can be made by the remote control for VRV and HRV unit.
The setting of mode No. 19 (29) and 40 can be made only by the remote control for VRV unit. The
mode No. 30 is used for the individual setting such as the calculation of power bill, etc.
2. The mode No. in ( ) is used for making individual setting of each unit.
3. Group number setting for centralized control
1. Mode no. 00: Group control
2. Mode no. 30: Individual control
∗ Regarding the setting procedure, refer to the section “Group number setting for centralized control” in
the operating manual of either the on / off control or the central control.
Caution 1. The setting positions are set at “01” at the factory.
The ventilation air flow, however, is set at “05” (medium) in the HRV unit. When lower or higher setting
is desired, change the setting after installation.
Si33-102.book Page 88 Tuesday, June 26, 2001 3:18 PM
Все каталоги и инструкции здесь: http://splitoff.ru/tehn-doc.html
To Next Page
Loading...
Need help?
General
