SiE33-102 Test Operation
General Information 89
4.13 Centralized Control Group No. Setting
BRC1A51·52 If carrying out centralized control by central remote control or unified ON/OFF control, group No. must
be set for each group individually by remote control.
Group No. setting by remote control for centralized control
1. When in the normal mode, push the button for 4 seconds or more, and operation then enters
the “field setting mode.”
2. Set mode No. “00” with the button. ∗
3. Push the button to inspect the group No. display.
4. Set the group No. for each group with the button (The group No. increases in the manner of 1-00,
1-01, ...,1-15, 2-00,...4-15. However, the unified ON/OFF control displays only the group No. within
the range selected by the switch for setting each address.)
5. Push the timer button to define the selected group No.
6. Push the button to return to the normal mode.
Even if not using a remote control, connect the remote control when setting the group No., set the group
No. for centralized control, and disconnect after making the setting.
Set the group No. after turning on the power supply for the central remote control, unified ON/OFF
control, and indoor unit.
BRC7A Type Group No. setting by infrared remote for centralized control
1. When in the normal mode, push button for 4 seconds or more, and operation then enters the
“field set mode.”
2. Set mode No. “00” with button.
3. Set the group No. for each group with button (advance/backward).
4. Enter the selected group numbers by pushing button.
5. Push button and return to the normal mode.
BRC7A Type
Si33-102.book Page 89 Tuesday, June 26, 2001 3:18 PM
Все каталоги и инструкции здесь: http://splitoff.ru/tehn-doc.html
To Next Page
Loading...
Need help?
General
