Dalsa Xtium2-CLHS PX8 User Manual

98 • Appendix A: Silent Installation Xtium2-CLHS PX8 User's Manual
Custom Driver Installation using install.ini
Customize the driver installation by parameters defined in the file “install.ini”.
By using this file, the user can:
 Select the user default configuration.
 Select different configurations for systems with multiple boards.
 Assign a standard Serial COM port to board.
Creating the install.ini File
 Install the driver in the target computer. All Xtium2-CLHS PX8 boards required in the system
must be installed.
 Configure each board’s acquisition firmware using the Teledyne DALSA Device Manager tool
(see Device Manager – Board Viewer).
 When each board setup is complete, using the Teledyne DALSA Device Manager tool, click on
the Save Config File button. This will create the “install.ini” file.
Figure 35: Create an install.ini File
Run the Installation using install.ini
Copy the install.ini file into the same directory as the setup installation file. Run the setup
installation as normal. The installation will automatically check for an install.ini file and if found, use
the configuration defined in it.

Dalsa Xtium2-CLHS PX8 Specifications

General

Brand	Dalsa
Model	Xtium2-CLHS PX8
Category	Media Converter
Language	English