Danfoss Vacon NXP Series - Page 5

7.4 Installation of Option Boards 83
7.5 Galvanic Isolation Barriers 83
8 Using the Control Panel 85
8.1 Navigating on the Control Panel 85
8.2 Using the Monitoring Menu (M1) 85
8.2.1 Monitored Values 86
8.3 Using the Parameter Menu (M2) 87
8.3.1 Finding the Parameter 87
8.3.2 Selecting Values 88
8.3.3 Editing the Values Digit by Digit 89
8.4 Using the Keypad Control Menu 90
8.4.1 Finding the Keypad Control Menu 90
8.4.2 Keypad Control Parameters M3 91
8.4.3 Changing the Control Mode 91
8.4.4 Keypad Reference 92
8.4.5 Changing the Rotation Direction 92
8.4.6 Disabling the Stop Motor Function 93
8.4.7 Special Functions in Keypad Control Menu 93
8.5 Using the Active Faults Menu (M4) 94
8.5.1 Finding the Active Faults Menu 94
8.5.2 Examining the Fault Time Data Record 95
8.5.3 Fault Time Data Record 95
8.6 Using the Fault History Menu (M5) 96
8.6.1 Fault History Menu (M5) 96
8.6.2 Resetting the Fault History 97
8.7 Using the System Menu (M6) 97
8.7.1 Finding the System Menu 97
8.7.2 System Menu Functions 97
8.7.3 Changing the Language 100
8.7.4 Changing the Application 100
8.7.5 Copy Parameters (S6.3) 101
8.7.6 Security 104
8.7.7 Keypad Settings 107
8.7.8 Hardware Settings 108
8.7.9 System Info 111
8.8 Using the Expander Board Menu 114
8.8.1 Expander Board Menu 114
8.8.2 Examining the Connected Option Boards 114
8.8.3 Finding the Option Board Parameters 115
8.9 Further Control Panel Functions 115
Contents
Operating guide | VACON® NXS/NXP Air-cooled
DPD00910G | 5Danfoss A/S © 2018.06