1 Standard 2 PROFIBUS
Illustration 25: FR8
8. Attach the cover of the drive. For the tightening torques of the screws, see 12.5 Tightening Torques for Cover Screws.
6.5.5 Installing the Cables, FR9
Context:
Follow these instructions to install the cables.
For information on how to comply with the UL regulations in cable installations, see 6.1.2 UL Standards on Cabling.
If it is necessary to connect an external brake resistor, see VACON
®
Brake Resistor Manual. See also 8.7.8.2 Setting the Internal Brake
Resistor Connection.
Prerequisites:
Make sure that the delivery contains all necessary components.
Open the covers according to instructions in 6.4.6 Get Access and Locate the Terminals for FR9.
Electrical Installation
Operating guide | VACON® NXS/NXP Air-cooled
DPD00910G
66 | Danfoss A/S © 2018.06
To Next Page
Loading...
