Danfoss Vacon NXP Series - Editing the Values Digit by Digit

Prerequisites:
When the drive is in RUN state, many parameters are locked, and cannot be edited. Only the text Locked shows on the display. Stop the
AC drive to edit these parameters.
Procedure
1. Use the Browser buttons Up and Down to find the parameter (P#) to edit. To move directly from the last parameter of a parameter
group to the first parameter of that group, push the Browser button Up.
READY
Keypad
e30bg026.10
Min Frequency
13.95 Hz
2. To go to the Edit mode, push the Menu button Right. The parameter value starts to blink.
READY
Keypad
e30bg028.10
Min Frequency
13.95 Hz
3. Set the new value with the Browser buttons Up and Down.
4. To accept the change, push the [enter] button or ignore the change with menu button Left.
If the [enter] button is pushed, the value stops to blink and the new value shows in the value field.
READY
Keypad
e30bg029.10
Min Frequency
14.45 Hz
5. For locking the parameter values, use the Parameter Lock function in menu M6, see 8.7.6.6 Locking a Parameter.
8.3.3 Editing the Values Digit by Digit
Context:
Use these instructions to edit the numerical values on the control panel.
The basic application package "All in One+" includes 7 applications with different sets of parameters. For more information, see
VACON
®
All in One Application Manual.
Prerequisites:
Using the Control Panel
Operating guide | VACON® NXS/NXP Air-cooled
DPD00910G | 89
Danfoss A/S © 2018.06