Danfoss VLT AutomationDrive FC 302

Option
Name
Description
[62]
Counter A (up)
[63]
Counter A (down)
[64]
Counter B (up)
[65]
Counter B (down)
[70]
Start timer 3
Starts timer 3, see parameter 13-20 SL Controller Timer for further description.
[71]
Start timer 4
Starts timer 4, see parameter 13-20 SL Controller Timer for further description.
[72]
Start timer 5
Starts timer 5, see parameter 13-20 SL Controller Timer for further description.
[73]
Start timer 6
Starts timer 6, see parameter 13-20 SL Controller Timer for further description.
[74]
Start timer 7
Starts timer 7, see parameter 13-20 SL Controller Timer for further description.
[120]
Start homing
N O T I C E
This option is available only with software version 48.20 and newer.
Activates the homing mode and starts the homing function selected in parameter 17-80 Hom-
ing Function. Must remain active until the homing is completed otherwise the homing is abor-
ted.
[121]
Stop homing
N O T I C E
This option is available only with software version 48.20 and newer.
Deactivates the homing mode, an active homing function is aborted if the homing is not com-
pleted.
[122]
Enable reference
N O T I C E
This option is available only with software version 48.20 and newer.
Sets the enable reference mode.
[123]
Disable reference
N O T I C E
This option is available only with software version 48.20 and newer.
Disables the enable reference mode.
[124]
Relative position
N O T I C E
This option is available only with software version 48.20 and newer.
Selects the relative position mode instead of the absolute position mode.
[125]
Absolute position
N O T I C E
This option is available only with software version 48.20 and newer.
AU275636650261en-000101 / 130R0334444 | Danfoss A/S © 2022.12
Parameter Descriptions
VLT AutomationDrive FC 301/302
Programming Guide