Danfoss VLT AutomationDrive FC 302

1 Introduction
1.1 Supported Software Versions
Supported software versions: 9.12 and 48.9X
This programming guide can be used for all FC 301 and FC 302 drives, and for VLT® Decentral Drive FCD 302. The software version
number can be read from parameter 15-43 Software Version.
1.2 Integrated Motion Controller
The integrated motion controller (IMC) enables position control. For more information about IMC, refer to the Chapter Integrated
Motion Controller.
AU275636650261en-000101 / 130R033412 | Danfoss A/S © 2022.12
Introduction
VLT AutomationDrive FC 301/302
Programming Guide