Danfoss VLT AutomationDrive FC 302 Programming Guide

•
•
5.18.8 18-6* Inputs & Outputs 2
Parameter 18-60 Digital Input 2
Table 1002: Parameter 18-60 Digital Input 2
18-60 Digital Input 2
Default value: 0
Parameter type: Range, 0 - 65535
Setup: All setups
Conversion index: 0
Data type: Uint16
Change during operation: False
Shows the signal states from the active digital inputs.
0 = No signal
1 = Connected signal
5.18.9 18-7* Rectifier Status
N O T I C E
This parameter group is only available in FC 302.
Parameter 18-70 Mains Voltage
Table 1003: Parameter 18-70 Mains Voltage
18-70 Mains Voltage
Default value: 0 V
Parameter type: Range, 0 - 1000 V
Setup: All setups
Conversion index: 0
Data type: Uint16
Change during operation: True
Shows the mains line-to-line voltage.
Parameter 18-71 Mains Frequency
Table 1004: Parameter 18-71 Mains Frequency
18-71 Mains Frequency
Default value: 0 Hz
Parameter type: Range, -100 - 100 Hz
Setup: All setups
Conversion index: -1
Data type: Int16
Change during operation: True
Shows the mains frequency.
Parameter 18-72 Mains Imbalance
Table 1005: Parameter 18-72 Mains Imbalance
18-72 Mains Imbalance
Default value: 0%
Parameter type: Range, 0 - 100%
Setup: All setups
Conversion index: -1
Data type: Uint16
Change during operation: True
Shows the maximum imbalance for the 3 mains line-to-line measurements.
Parameter 18-73 Worst Inrush
Table 1006: Parameter 18-73 Worst Inrush
18-73 Worst Inrush
Default value: 0
Parameter type: Range, 0 - 10000
Setup: All setups
Conversion index: 0
Data type: Uint16
Change during operation: True
AU275636650261en-000101 / 130R0334546 | Danfoss A/S © 2022.12
Parameter Descriptions
VLT AutomationDrive FC 301/302
Programming Guide

Danfoss VLT AutomationDrive FC 302 Specifications

General

Brand	Danfoss
Model	VLT AutomationDrive FC 302
Category	DC Drives
Language	English