Page 115
PR-01738 Ribbon Error
The printer cannot identify the ribbon installed.
Possible Cause 1: You have installed an unsupported print ribbon.
Solution 1: Press the Ready key to print one-color images using settings for
monochrome (K) ribbon. (The printer cannot use an unsupported print ribbon
to print full-color images.) If the printer is a monochrome printer and you
have installed a full-color print ribbon, install a monochrome print ribbon.
Possible Cause 2: You have installed a roll of Datacard print ribbon that is
not supported by the printer.
Solution 2: Make sure the new type of ribbon is approved for use with this
printer. Run the latest Firmware Update Utility to install support for the new
type of ribbon in this printer.
Possible Cause 3: You have installed a defective roll of Datacard print
ribbon.
Solution 3: Install another roll of Datacard print ribbon.
When you press the Ready key on the LCD panel, the message is not
displayed again even if the condition continues.
If you cannot fix the problem, contact your service provider for assistance.
To Next Page
Loading...
