Page 57
— If you have chosen DHCP, “Apply/Restart” appears on line 2. Press the Enter key to restart the printer.
After the printer restarts, see “View the Network Address Mode, IP Addresses, and MAC Address” on
page 51 to retrieve the IP address and other data.
— If you have chosen Static IP, “IP Address” appears on line 2. See “Set the IP Address, Subnet Mask, and
Gateway Address” on page 58 for the steps to follow.
— You must set the IP address, subnet mask, and gateway IP address for the printer. The printer will
restart after you enter these values.
— If you have used the DHCP/Static IP menu selection but did not actually change the address mode, “K
Power” appears on line 2. Press the Up or Down Arrow key to display “Exit” on line 2. Press the Enter key
repeatedly to return to the “Printer Ready” display.
To Next Page
Loading...
Need help?
General
