Page 35
Set up for your card design
The steps to set up for your card design depend on the Data Format you use.
Set up for SmartDriver
1 Install the SmartDriver. Choose “Direct Network” when installing the printer.
2 Install SP Series Info Central and e-Guide.
3 Open Info Central. In the contents list, locate the “Network Installation” topic in the “Installation” book. Scroll
down to the steps for your type of connections—wired or wireless—to complete driver installation.
4 In Info Central, locate the “Setting up for your card design” book. Follow the guidance provided to complete
driver and printer setup.
Set up for the Open Card data format
The Open Card option is required to use Open Card. See “Features and options” on page 3 to determine whether
you have the Open Card option.
1 Prepare the data by using Open Card commands. (At a minimum, use the Start and End Data commands.)
2 Use the Card Layout menus available through the printer Telnet interface to set up a card design.
3 See the SP Series Data Formatting Guide for more information.
To Next Page
Loading...
Need help?
General
