EasyManuals Logo

DataCard SP25 Plus User Manual

DataCard SP25 Plus
134 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #75 background imageLoading...
Page #75 background image
Page 70
IS-01206 No Card Picked
A card was not picked successfully.
Possible Cause 1: The input hopper is empty.
Solution 1: Fan the edges of the cards so the printer picks one card at a
time and then load cards in the input hopper. Push the input hopper cover
closed until it latches.
Possible Cause 2: One or two cards are jammed going into the printer.
Solution 2 a: Release the stuck card(s). Fan the cards in the input hopper
again to separate them.
Solution 2 b: Cleaning liquid is making cards slip on the pick roller. Wait one
or two minutes with the input hopper open to allow the pick roller to dry.
If the problem occurs again, run a cleaning card, change the cleaning
sleeve, and then clean the rollers in the printer.
Related Topics:
“Loading cards” on page 5
“Cleaning the printer” on page 39
“Cleaning the printer rollers” on page 41

Table of Contents

Other manuals for DataCard SP25 Plus

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the DataCard SP25 Plus and is the answer not in the manual?

DataCard SP25 Plus Specifications

General IconGeneral
BrandDataCard
ModelSP25 Plus
CategoryPrinter
LanguageEnglish

Related product manuals