Page 55
Set the Data Format
Tips for success
• When you choose a data format, the printer might not operate properly if data in another format is sent.
• If you have the SmartDriver installed and connected to the printer, suspend communication using the Printer
Toolbox before changing values. If you change the data format, unexpected cards might be printed.
1 With “Configuration” displayed on line 1, press the Up or Down Arrow key if needed
to display “Data Format” on line 2.
2 Press the Enter key. The current data format value is displayed on line 2.
3 Press the Up or Down Arrow key to display the data format you want. Possible
values are SmartDriver, Open Card (requires the Open Card option), and
Reserved. The Reserved value is not supported.
4 Press the Enter key. “Apply/Restart” appears on line 2.
5 Press the Enter key to apply the value(s) and restart the printer.
6 If you did not choose a different data format, the display shows “DHCP/Static IP” on
line 2. Press the Up or Down Arrow key to scroll to “Exit” on line 2 to leave without
making changes.
When the printer restarts, the Ready light shows amber (yellow) and then blinks green.
Internal printer components move and the LCD panel changes to show “Printer Ready” on the first line.
To Next Page
Loading...
Need help?
General
