Page 31
— Press the Enter key to leave the current value.
— Press the Up or Down Arrow key to scroll to a value and
press Enter to view the value.
— Exit to the Main Menu and continue with “Set the Data
Format” on page 34.
— If you need to change the address mode, continue with
these steps.
6 Press the Enter key to exit from the Status Menu to the Main
Menu. Press the Up or Down Arrow key to scroll to
“Configuration,” and then press the Enter key.
7 Press the Up or Down Arrow key to scroll to “DHCP/Static IP”
and then press the Enter key.
8 Press the Up or Down Arrow key to choose the address mode
you want and then press the Enter key.
— If you choose DHCP, the display shows “Apply/Restart” on
line 2. If you are not connected to a DHCP network, the IP
address will be blank until you connect the printer to the
network. Continue with step
9.
To Next Page
Loading...
Need help?
General
