D-100 MK2 User Manual Firmware V-6.3
K96D01-EN - 119 -
Below is a shortlist of available Modbus registers. For complete register map please refer to D-500/700
Modbus Application Manual.
Pushbutton simulation
BIT 0.Simulate Stop button
BIT 1.Simulate Manual button
BIT 2.Simulate Auto button
BIT 3.Simulate Test button
BIT 4.Simulate Run button
BIT 5.Simulate GCB button
BIT 7.Simulate Menu+ button
BIT 8.Simulate Menu- button
BIT 9.Simulate Up button
BIT10.Simulate Down button
BIT14.Button Long pressed
BIT15.Button Very Long Pressed
Mains phase L1-L2 voltage
Mains phase L2-L3 voltage
Genset phase L1-L2 voltage
Genset phase L2-L3 voltage
Genset phase L3-L1 voltage
Genset total active power
Mains total reactive power
Genset total reactive power
Mains total apparent power
Genset total apparent power
Genset total power factor
Oil pressure in bars (multiply by 14.50 to for psi)
Engine temp in °C (multiply by 1.8 then add 32 for °F)
Oil temp in °C (multiply by 1.8 then add 32 for °F)
Canopy temp in °C (multiply by 1.8 then add 32 for °F)
Ambient temp in °C (multiply by 1.8 then add 32 for °F)
To Next Page
Loading...
Need help?
General
