Datalogic DS8100A User Manual

DS8100A REFERENCE MANUAL
88
9
To run each instruction press the Next button. The procedure repeats the steps asking to
change the PCT-8000 X position (i.e. always before the PS Line (reference point) and
parallel to a conveyor edge but changing to the left-hand edge and/or to the center of the
conveyor), until the procedure terminates. At the end of the procedure, only the Stop
button is active. Typically 3 passes are necessary.

Datalogic DS8100A Specifications

General

Brand	Datalogic
Model	DS8100A
Category	Barcode Reader
Language	English