Datalogic Gryphon GBT4500 Series User Manual

Charging the Batteries
QUICK REFERENCE GUIDE 11
Figure 11 - Multiple Stand Alone Layout
Many stand alone connections can operate in the same
physical area without interference, provided all readers
and cradles in the system have different addresses.
CHARGING THE BATTERIES
To charge the battery, simply insert the Gryphon into the
base. When the scanenr is fully seated in the cradle, it will
sound a “chirp” to indicate that the cradle has detected
the scanner connection.
The LEDs on the base (shown in Table 1 on page 12) will
indicate the status of the battery.
NOTE: The Gryphon GBT/GM4500 may get warm
during charging: this is normal and does not mean
a malfunction.
NOTE: Before using the battery, read "Battery
Safety" on page 47. Datalogic recommends annual
replacement of rechargeable battery packs to
ensure maximum performance.

Datalogic Gryphon GBT4500 Series Specifications

General

Drop Resistance	1.8 m / 5.9 ft
Sealing	IP52
Operating Temperature	0 to 50 °C / 32 to 122 °F
Light Source	LED
Storage Temperature	-20 to 70 °C / -4 to 158 °F
Ambient Light	0 - 100, 000 lux
Drop Specification	Withstands repeated drops from 1.8 m / 5.9 ft onto a concrete surface
IP Rating	IP52
Connectivity	Bluetooth
Battery Type	Lithium-Ion
Decode Capability	1D / 2D, Postal Codes, Stacked Codes
Radio Range (Open Air)	Up to 100 m / 328 ft
Interfaces Supported	USB, RS-232, Keyboard Wedge
Type	Handheld
Technology	2D imager
Scan Rate	60 frames/sec
Supported Barcodes	1D, 2D, Postal
Humidity	5 - 95% (Non-condensing)
Power Supply	5 VDC
Battery	Rechargeable Battery Pack
Weight	245.0 g / 8.6 oz