Datalogic Gryphon GBT4500 Series User Manual

Configuring the Interface
QUICK REFERENCE GUIDE 19
CONFIGURING THE INTERFACE
Scan the appropriate programming bar code to select the
interface type for your system.
NOTE: Unlike some other programming features
and options, interface selections require that you
scan only one programming bar code label. DO
NOT scan an ENTER/EXIT bar code prior to scan-
ning an interface selection bar code.
Some interfaces require the scanner to start in
the disabled state when powered up. If additional
scanner configuration is desired while in this
state, pull the trigger and hold for 5 seconds. The
scanner will change to a state that allows pro-
gramming with bar codes.
RS-232
Select RS232-STD
RS-232 standard interface
Select RS232-WN
RS-232 Wincor-Nixdorf
Select RS-232 OPOS
RS-232 for use with OPOS/UPOS/JavaPOS
Select USB-COM-STD
a
USB Com to simulate RS-232 standard interface
a. Download the correct USB Com driver from www.datalogic.com

Datalogic Gryphon GBT4500 Series Specifications

General

Drop Resistance	1.8 m / 5.9 ft
Sealing	IP52
Operating Temperature	0 to 50 °C / 32 to 122 °F
Light Source	LED
Storage Temperature	-20 to 70 °C / -4 to 158 °F
Ambient Light	0 - 100, 000 lux
Drop Specification	Withstands repeated drops from 1.8 m / 5.9 ft onto a concrete surface
IP Rating	IP52
Connectivity	Bluetooth
Battery Type	Lithium-Ion
Decode Capability	1D / 2D, Postal Codes, Stacked Codes
Radio Range (Open Air)	Up to 100 m / 328 ft
Interfaces Supported	USB, RS-232, Keyboard Wedge
Type	Handheld
Technology	2D imager
Scan Rate	60 frames/sec
Supported Barcodes	1D, 2D, Postal
Humidity	5 - 95% (Non-condensing)
Power Supply	5 VDC
Battery	Rechargeable Battery Pack
Weight	245.0 g / 8.6 oz