Datalogic Gryphon GBT4500 Series User Manual

Reading Parameters
QUICK REFERENCE GUIDE 29
READING PARAMETERS
Move the reader toward the target and center the aiming
pattern and illumination system to capture and decode
the image. See "Using the Gryphon™ I GBT/GM4500" on
page 14 for more information.
The aiming system will briefly switch off after the acquisi-
tion time, and if no code is decoded will switch on again
before the next acquisition. The illuminator will remain on
until the symbol is decoded.
As you read code symbols, adjust the distance at which
you are holding the reader.
Aiming System
A number of options for customizing control of the Aiming
System are available. See the Gryphon™ I GD/GBT/
GM4500 PRG for more information and programming bar
codes.
Good Read Green Spot Duration
Successful reading can be signaled by a good read green
spot. Use the bar codes that follow to specify the duration
of the good read pointer beam after a good read.
GOOD READ GREEN SPOT DURATION
ENTER/EXIT PROGRAMMING MODE
Disable
★ Short (300 ms)

Datalogic Gryphon GBT4500 Series Specifications

General

Drop Resistance	1.8 m / 5.9 ft
Sealing	IP52
Operating Temperature	0 to 50 °C / 32 to 122 °F
Light Source	LED
Storage Temperature	-20 to 70 °C / -4 to 158 °F
Ambient Light	0 - 100, 000 lux
Drop Specification	Withstands repeated drops from 1.8 m / 5.9 ft onto a concrete surface
IP Rating	IP52
Connectivity	Bluetooth
Battery Type	Lithium-Ion
Decode Capability	1D / 2D, Postal Codes, Stacked Codes
Radio Range (Open Air)	Up to 100 m / 328 ft
Interfaces Supported	USB, RS-232, Keyboard Wedge
Type	Handheld
Technology	2D imager
Scan Rate	60 frames/sec
Supported Barcodes	1D, 2D, Postal
Humidity	5 - 95% (Non-condensing)
Power Supply	5 VDC
Battery	Rechargeable Battery Pack
Weight	245.0 g / 8.6 oz