SET KEY SEQUENCE ID ENTER/EXIT PROGRAMMING MODE
PRODUCT REFERENCE GUIDE
273
Set Key Sequence ID
Sets the identifier for keyboard composed strings.
Set Key Sequence Header
Sets the header for keyboard composed strings.
Set Key Sequence Terminator
Sets the terminator for keyboard composed strings.
Set keys sequence ID
$CPWEC
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code
at left followed by 6 digits from Appendix G, Keypad.
The ID characters must be represented by their
hexadecimal ASCII code; if the first 2 digits are 0, this
feature is disabled. End by scanning the ENTER/EXIT
bar code again.
Set key sequence header
$CPWE1
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code
at left followed by 32 digits from the Alphanumeric
characters in Appendix G, Keypad. The digits must
be the hexadecimal ASCII representation of the
desired characters.
If less than the expected string of 16 characters are
selected, scan the ENTER/EXIT bar code to terminate
the string.
If the first 2 digits are 0, the feature is disabled. End
by scanning the ENTER/EXIT bar code again.
Set key sequence terminator
$CPWE2
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code
at left followed by 32 digits from the Alphanumeric
characters in Appendix G, Keypad. The digits must
be the hexadecimal ASCII representation of the
desired characters.
If less than the expected string of 16 characters are
selected, scan the ENTER/EXIT bar code to terminate
the string.
If the first 2 digits are 0, the feature is disabled. End
by scanning the ENTER/EXIT bar code again.
To Next Page
Loading...
Need help?
General
