Name: Datalogic PowerScan Series
Brand: Datalogic
Rating: 5 (1 reviews)

To Next Page

To Previous Page

ENTER/EXIT PROGRAMMING MODE RS-232/USB-COM INTERFACES

POWERSCAN™ PD/PM/PBT9600

RS-232/USB-COM SETTINGS

Intercharacter Delay

This parameter specifies the intercharacter delay between the end of one character and

the beginning of the next. The delay can be set within a range of zero (0) to 990 millisec-

onds in 10ms increments. A setting of zero specifies no delay. See "

Intercharacter Delay"

on page 316

for more detailed programming instructions.

$CR2IC00

Intercharacter Delay = No Delay

Select Intercharacter Delay Setting

$CR2IC

To configure this feature, scan the ENTER/EXIT bar

code above, then the bar code at left followed by dig-

its from the Alphanumeric characters in Appendix G

representing your desired character(s). End by scan-

ning the ENTER/EXIT bar code again.

Make a mistake? Scan the CANCEL bar code to abort

and not save the entry string. You can then start

again at the beginning.

CANCEL



00 = No Intercharacter Delay

Questions and Answers:

Need help?

Do you have a question about the Datalogic PowerScan Series and is the answer not in the manual?

Datalogic PowerScan Series Specifications

General