REAL TIME CLOCK (RTC) CONFIGURATION ENTER/EXIT PROGRAMMING MODE
PRODUCT REFERENCE GUIDE
295
Date-Time Separator
Sets the character used to separate Date and Time from the next field in message.
$CRFTD0000\r
Disable Date-Time Separator
Set Character Separator =
$CRFTD01\r
To configure this feature, scan the ENTER/EXIT
PROGRAMMING MODE bar code above, then the
bar code at left followed by 2 digits from the
Alphanumeric characters in
Appendix G, Keypad
representing your desired character(s). End by
scanning the ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to
abort and not save the entry string. You can then
start again at the beginning.
CANCEL
To Next Page
Loading...
