BC9600 CONFIGURATION
PRODUCT REFERENCE GUIDE
35
BC9600 CONFIGURATION
The BC9600 configuration can be performed in three ways: by using the Datalogic Alad-
din™ software configuration program, by sending configuration strings from the Host PC
via the RS-232, USB-COM or Ethernet interface or by reading configuration bar codes
with the PowerScan 9600 reader.
Serial Configuration
By connecting the BC9600 to a PC through an RS-232 or USB-COM interface cable it is
possible to send configuration strings from the PC to BC9600.
Configuration Bar Codes
Link the cradle and the reader using the procedures described in the PowerScan PBT/
PM9600 Quick Reference. Once the pairing is complete, you can configure the BC9600
cradle by reading configuration bar codes in this manual.
To configure the BC9600 using the PowerScan 9600 reader (paired to the cradle with the
Bind command), follow the procedure according to the interface selected.
INTERFACE SELECTION
Upon completing the physical connection between the reader and its host, proceed
directly to the following paragraph "Configuring the Interface" for information and pro-
gramming for the interface type the reader is connected to (for example: RS-232, USB,
etc.) and scan the appropriate bar code in that section to select your system’s correct
interface type.
The reader, depending upon the model, will support one of the following sets of host
interfaces:
• USB (Keyboard, COM, OEM)
• USB Composite (Keyboard + COM)
• USB HID POS
• USB Toshiba TEC
• RS-232 STD
• RS-232 WN
• RS232 OPOS
• Datalogic Magellan Scanners' specific interface
• Ethernet
To Next Page
Loading...
Need help?
General
