STANDARD DEFAULTS
362
POWERSCAN™ PD/PM/PBT9600
Controller Output Data Buffer Size 16 byte 96
DATA FORMAT
Global Prefix/Suffix
No Global Prefix
Global Suffix = 0x0D (CR)
98
Case Conversion Disable (no case conversion) 99
Character Conversion
0xFFFFFFFFFFFFFFFF
(no character conversion)
99
Global AIM ID Disable 100
GS1-128 AIM ID Enable 100
Label ID: Pre-loaded Sets USA Set 101
Label ID Control Disable 102
Label ID Symbology Selection 103
READING PARAMETERS
Scan Mode Trigger Single 109
Scanning Active Time 5 seconds 110
Flash On Time 10 = Flash is ON for 1 second 110
Flash Off Time 06 = Flash is OFF for 600ms 111
Double Read Timeout 0.6 second 111
Stand Detection Behavior (Desk
only)
Ignore Autorecognition 113
Stand Mode/Object Detection Indica-
tion (Stand Mode Flash)
Disable 114
Stand Mode/Object Detection Sensi-
tivity
Medium 114
Stand Mode/Object Detection Illumi-
nation Off Time
1 second 115
Illumination Intensity Full Intensity 115
Corded Stand Mode Disable 116
Dock Detection Beep Disable 116
Power On Alert
Power-up Beep
117
Good Read Beep Type Mono 117
Good Read Beep Frequency Medium 118
Good Read Beep Length 80 msec 119
PARAMETERS DEFAULT
YOUR SETTING PAGE NUMBER
To Next Page
Loading...
Need help?
General
