Enter/Exit Programming Mode
178 QuickScan™ I QD24XX
Aztec Code Set Length 2
This feature specifies one of the bar code lengths for Aztec Code Length Control. Length 2 is the maximum label
length if in Variable Length Mode, or the second fixed leng
th if in Fixed Length Mode. Characters can be set from
0001 to 3,832 characters in increments of 0001 (pad with zeroes).
See page 217 for detailed instructions on setting this feature.
Select Aztec Code Length 2 Setting
To configure this feature, scan the ENTER/EXIT PROGRAM-
MING MODE bar code above, then the bar code at left fol-
lowed by the digits from the Alphanumeric characters in
Appendix D, Keypad representing your desired charac-
ter(s). End by scanning the ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to
abort and
not save the entry string. You can then start again at the
beginning.
CANCEL
Length 2 is 3,832 Characters
To Next Page
Loading...
Need help?
General
