Enter/Exit Programming Mode
76 QuickScan™ I QD24XX
Aiming Duration Timer
Specifies the frame of time the aiming pointer remains on after decoding a label, when in trigger single mode.The
range for this setting is from 1 to 255 seconds in 1-second increments. See page 231 in “References” for a
description of this feature.
Aiming Off After Decoding
Set Aiming Duration Timer
To configure, scan the ENTER/EXIT PROGRAMMING MODE
bar code above, then the bar code at left followed by the
digits from the Alphanumeric characters in Appendix D,
Keypad representing your desired character(s). End by
scanning the ENTER/EXIT bar code.
Make a mistake? Scan the CANCEL bar code to
abort and
not save the entry string. You can then start again at the
beginning.
CANCEL
To Next Page
Loading...
Need help?
General
