Product Reference Guide 19
RS-232 INTERFACE
BAUD RATE on page 20
DATA BITS on page 21
STOP BITS on page 21
PARITY on page 22
HANDSHAKING CONTROL on page 23
Use the programming bar codes in this section if modifications to the stan
dard RS-232 interface settings are
necessary to meet your system’s requirements. Additional settings which apply to both the RS-232 and USB
interfaces are available in the next section, "RS-232/USB-Com Interfaces" start
ing on page 24.
Reference Appendix B, Standard Defaults for a listing of standard factory settings.
To Next Page
Loading...
