Datalogic QuickScan I QD2400 User Manual

Enter/Exit Programming Mode
48 QuickScan™ I QD24XX
Global Prefix/Suffix
This option sets up to 20 characters each from the set of ASCII characters or any hex value from 00 to FF. The
characters may be added as a prefix (in a position before the bar code data, also called a header) and/or as a suffix (in
a position following the bar code data, also called a footer). See page 219 for more detailed instructions on setting
this feature.
To configure this feature, scan the ENTER/EXIT PROGRAMMING MODE bar code above
to place the unit in
Programming Mode, then the “Set Global Prefix” or “Set Global Suffix,” bar code followed by the digits (in hex)
from the Alphanumeric characters in Appendix D, Keypad representing your desired character(s). If less than the
expected string of 20 characters are selected, scan the ENTER/EXIT bar code to terminate the string.
Exit
programming mode by scanning the ENTER/EXIT bar code again.
$CLFPR
Set Global Prefix
$CLFSU
Set Global Suffix
Make a mistake? Scan the CANCEL bar code to abort and not
save the entry string. You can then start again at the begin-
ning.
~
CANCEL
DEFAULT
No Global Prefix
Global Suffix = 0x0D (CR)

Datalogic QuickScan I QD2400 Specifications

General

Brand	Datalogic
Model	QuickScan I QD2400
Category	Barcode Reader
Language	English