Datalogic QuickScan I QD2400 - Individually Set Label ID; Label ID Control

Enter/Exit Programming Mode
Product Reference Guide 53
Individually Set Label ID
This feature configures a Label ID individually for a single symbology. To set, first define whether you want it as a
prefix or suffix by scanning a label below. Then turn to Label ID Symbology Selection • 1D S
ymbologies, starting
on page 54 to select the symbology you want to set, followed by up to 3 characters from the ASCI
I Chart at the
back of this manual. See "Label ID: Set Individually Per Symbology" on page 224 for detailed
instructions on
setting this feature.
Label ID Control
This option controls whether a Label ID is disabled, or sent as a prefix or suffix for a given symbology type.
DEFAULT
$CIDCO00(CR)
Label ID Transmission = Disable
$CIDCO01(CR)
Label ID Transmission = Enable as Prefix
$CIDCO02(CR)
Label ID Transmission = Enable as Suffix