Enter/Exit Programming Mode
60 QuickScan™ I QD24XX
Character Conversion
Character conversion is an eight byte configuration item. The eight bytes are 4 character pairs represented in
hexadecimal ASCII values. The first character in the pair is the character that will be converted. The second
character in the pair is the character to convert to. If the character to convert in a pair is FF, then no conversion is
done.
Configure Character Conversion
DEFAULT
0xFFFFFFFFFFFFFFFF
(No character conversion)
If less than the expected string of 16 characters are selected, scan the ENTER/EXIT bar code twice
to accept the selections and exit Programming Mode.
To Next Page
Loading...
