Enter/Exit Programming Mode
16 QuickScan™ I QD24XX
3. If additional input parameters are needed, go to Appendix D, Keypad, and scan the appropriate characters
from the keypad.
Additional information about many features can be found in the “References” chapter.
If you make a mistake before the last character, scan the CANCEL bar code to abort and not
sav
e the entry string. You can then start again at the beginning.
4. Complete the programming sequence by scanning the ENTER/EXIT PROGRAMMING bar code to exit
Programming Mode.
For more detailed descriptions, programming information and examples for setting selected confi
guration items,
see R
eferences, starting on page 205.
By default, the handheld will decode bar code labels only when they are close to the center
of the aiming pattern. This allows the handheld to accurately target labels when they are
placed close together, such as on a pick sheet. See
Pick Mode, starting on page 72.
To Next Page
Loading...
Need help?
General
